HIGH POWER MICROWAVE DEVICES

Ferrite Waveguide
Isolator

This microwave device is designed for protection of microwave signal source from reflected microwave power. The device is made as combination of circulator that provides path for microwave signal in one direction nearly with no losses, and matched load that fully absorbs reflected microwave signal power.

Ferrite Waveguide
Circulator

This microwave device is designed for microwave signal direction. The device provides microwave signal transmission in one direction (from one of inputs to next in order output) per application of constant magnetic field.

Ferrite Waveguide
Switch

This microwave device is designed for microwave signal switch in direction. The device is made as circulator but with source of alternating magnetic field instead of constant magnetic field, so it could switch direction of microwave signal from one input into any output by command from external control device.

Ferrite Waveguide
Attenuator

This microwave device is designed for microwave power regulation within the path per absorbtion of microwave signal power to preset level, without its reflection or dissipation into environment. The device provides attenuated microwave power of due level after absorbtion further to the path.

Microwave Load

This microwave device provides full absorbtion of microwave power of the path without its reflection or dissipation into environment; also it could be used as microwave signal source dummy for set-up of due devices. We make microwave loads on base of ferrites or ceramics and with waveguide or coaxial input/output type.

Waveguide Directional
Coupler

This microwave device is designed for partial branching of microwave signal from main path into additional path per coupling ratio and coupling direction required. The device provides measurement of passing microwave power (incident power) and reflected microwave power levels.

PARTS OF MICROWAVE WAVEGUIDE-FEEDER PATH

Cross-section connections, loop connections, turns, contact waveguide interfaces, empty waveguides - that are required for mounting microwave devices into waveguide-feeder path.

WAVEGUIDE MICROWAVE DEVICES REPAIR SERVICE

Replacement of magnetic system, replacement of cooling system, SWR set-up.

+ BACK TO MAIN PAGE